Sea Battle strategy: where to place ships and how to find them
Firing at random takes about 87 shots to sink a full fleet. With the three methods below it takes about 39. We tested every tip on this page in 2,000 simulated games on the standard 10 by 10 board.
The short version
- Placing: let your ships touch the edge of the board. Against a computer that hunts by probability, edge fleets survived about 6 shots longer.
- Searching: fire on a checkerboard pattern. Every ship covers at least two squares, so half the board is enough to find them all.
- After a hit: try the four squares around it, then follow the line until the ship sinks.
The rules this guide uses
These are the rules of our Sea Battle game and the most common version of Battleship: a 10 by 10 grid, a fleet of five ships (Carrier 5, Battleship 4, Cruiser 3, Submarine 3 and Destroyer 2, so 17 squares in all) and ships that may not touch each other, not even at the corners. Because ships never touch, every square around a sunk ship is water, and the game marks those squares for you.
How many shots each method needs
We played 2,000 games with each search method against fleets placed at random, following the rules above.
| Search method | Average shots | Best game | Worst game |
|---|---|---|---|
| Random shots | 86.6 | 58 | 99 |
| Hunt and target | 50.1 | 22 | 84 |
| Hunt and target on a checkerboard | 44.6 | 24 | 67 |
| Probability map | 38.8 | 24 | 60 |
Random firing does better here than in versions where ships can touch, because each sunk ship clears its surrounding squares. Even so, a little method cuts the game roughly in half.
1. Hunt and target
Split the game into two modes. In hunt mode you have no unfinished hits, so you search for a new ship. As soon as you score a hit, switch to target mode:
- Fire at the four squares above, below, left and right of the hit.
- When you get a second hit, the ship lies along that line. Keep firing along it in both directions.
- When the ship sinks, go back to hunting. Do not waste shots next to the sunk ship: those squares are always water.
This alone takes the average from 87 shots to 50.
2. Search on a checkerboard
Picture the board as a chessboard and only fire at the dark squares while you hunt. The smallest ship covers two squares side by side, and any two neighbouring squares include one dark square, so no ship can hide from the pattern. You check 50 squares instead of 100.
The trick gets stronger as the game goes on. Once the Destroyer is sunk the smallest ship left is 3 long, so you only need every third square on each row. Once only the Carrier is left, every fifth square is enough.
3. Fire where ships are most likely
The strongest method counts, for every square, how many ways the remaining ships could still be placed over it. Middle squares can be covered by more positions than edge squares, so they light up first. Misses cut nearby positions away, and a hit makes every position running through it far more likely. The square with the highest count is the best next shot. Our Hard computer level hunts this way.
Try it on the map below. Tap a square once to mark a miss, twice to mark a hit, and a third time to clear it. Darker squares are more likely to hold a ship, and the outlined square is the best next shot.
The map counts the five-ship fleet still in play and treats your hits as unfinished ships. It does not apply the no-touching rule, so in a real game also skip squares next to sunk ships.
Where to place your ships
No placement is safe from a good searcher, but some are harder to find. In our tests the fleet layout made almost no difference against the checkerboard search. Against the probability search it mattered:
| How the fleet was placed | Shots needed by the probability search |
|---|---|
| Every ship touches the edge | 45.3 on average |
| Anywhere at random | 38.8 on average |
| No ship touches the edge | 34.8 on average |
The reason is the one the map shows: a probability searcher fires at the middle first, so ships along the edges stay hidden longer. A human opponent may know this and check the edges early, so do not make your layout predictable either:
- Mix horizontal and vertical ships. Once an opponent finds two ships pointing the same way, they start to guess the rest.
- Avoid neat patterns such as all five ships in a row, or a fleet copied from your last game.
- Keep the Destroyer away from your big ships. It is the hardest ship to find, and the last one hidden often decides the game.
Common mistakes
- Firing next to a sunk ship. Ships never touch, so those squares are always water.
- Forgetting which ships are left. If only the Carrier is afloat, a gap of four squares cannot hold it. Skip it.
- Leaving a hit unfinished. An open hit is the most valuable square on the board. Finish that ship before you hunt again.
Play Sea Battle against the computer
Common questions
What is the best first shot in Sea Battle?
With nothing known, the squares near the middle of the board can be covered by the most ship positions, so they are the most likely to hold a ship. Any dark square of the checkerboard near the centre is a good start.
Is Sea Battle the same as Battleship?
Yes. Sea Battle, Battleship and Battleships are names for the same pencil-and-paper game. Some versions let ships touch or use a different fleet; this guide uses the common five-ship fleet with no touching.
How did you test these tips?
We wrote a small program that plays Sea Battle by our game's rules. It placed fleets at random (or along the edges, or away from them) and played 2,000 games with each search method, counting the shots needed to sink every ship.
More strategy guides: Minesweeper patterns, Water Sort tips and how to solve Nonograms.